Flexible Rails Track Pipe Tank Welding Tractor with Oscillate Torch Holder
HK-100S tractor is automatic device. It can get wider welding seam after a time welding. It is very suitable for arc welding, the diameter of which is more than 750MM.You can adjust swing speed, swing angle, off-set position of centre and stopping time of left and right. It is suitable for various beads. The biggest speed is 1250mm/min in weldless station.
HK-100S is made up of body, control case, X-Y slide blocks, blowtorch holder, guide wheel and straight track.
1)Body: It is the driving device, which includes motor, planet reducing box, driving gear and track wheel.
2)Control casing: To control the movement of carriage. Please refer to control panel manual.
3)Cross device: You can use it in the process of straight welding (such as container case) to adjust the position of torch in case of moving track.
4)X-Y trimming slide blocks: It is convenient to adjust the blowtorch up and down or left and right.
5)Swing device: To execute various welding model.
6)Holder of blowtorch: It can hold the blowtorch and adjust the angle of blowtorch easily. Notice: Must not hold the conductive section, which may lead to short out or electric shock.
7)Plug seat of source: It is the plug seat of external electric cable, which is connected with earth wire.This plug seat is in charge of connecting carriage to feeder and supply the power for system. (There are two branches on the end of cable, one of which is used to connect feeder; another is used to connect source.)
1)Hand knob:It is used to move this machine. Please hold it fully.
2)On-off hand knob and demount hand knob:
8)Steel belt track: It is equipped with permanent magnet to make the track absorb to works to meet different welding needs. It is very suitable for arc welding, the diameter of which is more than 750MM.
9) Magnet: Strong on-off magnet. If you want to move the track, please turn all magnetron switches “OFF”.
10)Cable bracket: You can use it to carry cable to reduce the load of swing machine.
11)Blowtorch: User can choose straight blowtorch or bend blowtorch.
welding wire diameter welding parameter | Φ1.2mm | Φ1.4mm | Φ1.6mm | |
current(A) | Down hand welding | 120-300 | 150-380 | 180-430 |
flush fillet welding | 120-280 | 150-320 | 180-380 | |
horizontal welding | 120-280 | 150-300 | 180-330 | |
voltage(U) |
| |||
distance between nozzle and workpiece(H) |
| |||
welding extension length(L) | The length is about 10 times welding wire diameter. It is L=10d |
Packing list
The contents of the standard package are shown below. Check them carefully before assembling the machine.
1. | complete machine | 1set |
2. | The straight rail(1.8 m) | 1set |
3. | Standard power wire (16M) | 1set |
4. | Fuse(2A) | 2set |
5. | hex wrench | 1pc |
6. | Operating manual , Certificate of qualification | 1pc each |