Mig Welding Liner Miller M Series Hobart MIG Gun liner PTFE Graphite steel

Product parameters

Description

Fits Miller M Series Type Welding Gun

Steel Applicable to welding wire outer diameter 0.6-0.8-0.9-1.0-1.2mm(.023"-.030"-.035"-.040"-.045")

Teflon---Blue Applicable to welding wire outer diameter 0.6-0.8-0.9-1.0mm(.023"-.030"-.035"-.040")

Teflon---Red Applicable to welding wire outer diameter 1.0-1.2mm(.040"-.045")

Teflon---Yellow Applicable to welding wire outer diameter 1.2-1.6mm(.045"-1/16")

Graphite OD:4.0 Applicable to welding wire outer diameter 0.6-0.8-0.9-1.0mm(.023"-.030"-.035"-.040")

Graphite OD:4.7 Applicable to welding wire outer diameter 1.0-1.2-1.6mm(.040"-.045"-1/16")

Fits Miller M Series Type Welding Gun
Miller Mig Gun M-10, M-15, M-25, M-40, M-100, M-150, M31L, M32L, M33L, M34L, M38L,

This gun was used on some Miller 130 and 130 XP welders,

all Miller 135, 140, 175, 180, 185, 210, 212, 250X, 251, and 252 welders. Challenger 172, DVI.
Fits Hobart Mig Gun H-10
Perfect replacement for MILLER GUN LINER 194010 194011 194012 194T-011 194T-012 194T-013

Using the joint high temperature resistant nylon material customization,

To replace the traditional metal joint conductive resulting

in high temperature damage the welding torch cable

Graphite wire feeding liner, has the very strong hardness and smoothness
Can reduce wire maximum likelihood in the transmission process of wear
Very suitable for aluminum wire and stainless steel wire welding requirements
Suitable for aluminum welding wire and flux cored wire

Teflon can be used continuously at a temperature of 260 ℃,

with the highest use temperature is 290-300 ℃,

extremely low friction coefficient,

good wear resistance and excellent chemical stability

Please check the wire feed wheel type of joint before purchasing,

please confirm with the MIG gun you can joint matching

You will receive 10cm longer than the length you choose
In this way, you can install your welding torch and then cut to ensure

100% compliance with your welding torch length requirements